Agree, a smooth and beautiful floor can be considered an excellent decoration of any room. According to experts, the ability to align small surfaces is really possible for each. To begin with, it is necessary that the patch is that the aligned does not spread. And for success, you need to take care of directly about the preparation of the surface. After removing the plaster, it is necessary to thoroughly clean the floors of cement mortar flows. All potholes and dents that exceed 2 cm, we close. Now it is necessary to vacuum the floor. We are engaged in checking the loading surface for a certain porosity. To do this, you need to splash a little water on the replaced floor. However, if all the water is absorbed in less than a minute, then this means that the floor is quite porous and you need to carry out primary work. It is superimposed with a kind of painting roller, like a paint, and then thoroughly dried.
Pour the solution for the construction into a water bucket. Stir until the clot does gain a certain kind of homogeneous mass. After the solution is liquid and homogeneous, it is necessary to leave it for several minutes in the bucket. Now we overturn the bucket at the farthest wall of the room, and smear it with a cell, simultaneously removing the entire spectrum of clots and extraneous particles. The second layer is often applied after the first.
