The prepared frame is laid on the floor and covered it with trimming boards on top so that you can walk along them. Having placed the installation sites of vertical shields and all the bastards that put them on the lower frame on the pva jet.
Having made parts for the frame of vertical shields, the latter are assembled and installed on the lower frame. Check that the frames fit tightly to each other, and the upper faces are at the same height.
Having fixed the door block in the shield frame and making sure that the door is tightly approaching the box, they remove the door leaf, which is hanged later, lastly, last.
Having dismantled the “box” onto the frames, they fill the insulation of their cavity and sheathe shields with lining. For this, the frame is put in an even place. Its internal surface (in relation to the cabin) is covered with aluminum foil (with a lowering of strips) and sheathed with aspen lining.
Having turned the shield, put a heater into the formed “pockets”, for example, mineral wool slabs, and sheathed the frame with lining, leaving on top and below the forthcoming allowances for further assembly. Similarly come with other lateral and ceiling shields.
When assembling the cab on the frame, the front and the back shields are first installed. They are placed on dies. Then the side shields are installed on the frame. After making sure that the top of all the shields is at the same height, they put them through the side edges with nails. A ceiling shield is placed on top, which is fixed with dowels, and through the impact of the outer lining, additional fixes are fixed with nails.
Having laid the heater “in the pockets” of the floor, they cover it with foil and lay the floor boards.
Removable shelves and head restraints are easy to manufacture, they are attached to the walls of the cabin on the brackets. Skirting boards are nailed in the cab, and on the outlet from the outside — a layout that will close the hats of nails.
The walls of the sauna are decorated with carvings, fragments of which can be made separately from linden boards.
Do not forget that in the lower part of the shield, 2-4 ventilation holes of 020–40 mm must be made behind the installed electric chat, the throughput of which should be adjusted by the valve; Plaphon Electric lamps above the door must be sealed and closed by a decorative wooden shield, door handles — also made of wood.
The door leaf can be made continuous or double -tinted glass. The door itself should fit tightly to the box, it is good to put the seal.
