Comfortable accommodation in a private house does not do without an individual water supply system. As practice shows, the best sources are the well. The result of installation work will be the presence of a full -functioning engineering system that does not need additions and improvements, so the water supply scheme from the artesian well should be worked out immediately and in full.
A typical artesian well
If you are interested in the type of typical design, then you can imagine it like this:
At a distance of 10 m deeper from the water level, the pump is located;
Thanks to the pipes, water flows up;
The point of its purpose is a caisson — a device with automatic equipment inside that provides a well with thermal insulation and tightness.
Specialists who are drilling water wells know that in this process there are many nuances and subtleties, without which the water supply of a private house will not be perfect. So, for example, a special control unit with a manometer and a relay, as well as a membrane tank, allow you to achieve a constant and uniform supply of water to the house, and the pressure in this case will not change.
The arrangement of a complex well
If there are two or more directions for water (watering, bath, fountain, etc. D.), then the use of an expanded comb and various additional elements is provided. But in this case, the price of the arrangement of the well will not be too different from a similar process with the supply of water only to the house. Also, do not forget about compliance with the distance of the pipe laying. If water is used irregularly, then the depth should be much larger to exclude freezing in winter.
Factors affecting the cost
The price of an artesian well is quite justified, given that the consumer receives the following benefits:
high performance;
long life;
lack of the influence of technogenic environmental pollution;
100%of water is;
the possibility of using any rotary pumps (in sandy — only vibration — “baby”).
Ultimately, to calculate the cost of drilling, it should be taken into account the depth of the well and the cost of a linear meter. When multiplying these values, you can find out what the approximate cost of the drilling process will be. The final amount depends on the geology of this area and the initial diameter of the pipe. The design of the artesian well and the work technology are also of considerable importance.
